Oct 12
Bids in
15 days

20-E-8213 2019 Water System Improvements Contract I - Distribution Improvements

Hinds Co., MS (H-NR)


Accepting Bids

Bid Date10/12/21 10:00am

Company & Contacts

Engineering Service

Lori McIntire   601-939-8737

Bids for the construction of 2019 Water System Improvements, Contract I Distribution Improvements will be received at the office of the Engineer, located at 115 Aero Smith Drive, Richland, MS 39218, until 10:00 a.m. on Tuesday, October 12, 2021. At that time the Bids received will be publicly opened and read. Electronic bids will not be accepted for this project.

The Project includes the following Work: Approximately 4.2 miles of 24” waterline and 19.4 miles of 12” water line including valves, fittings, fire hydrants, disinfection & testing, etc.

Obtaining the Bidding Documents

Information and Bidding Documents for the Project can be found at the following website:

Bidding Documents may be viewed and purchased from the designated website. The website will be updated periodically with addenda, lists of registered plan holders, and other information relevant to submitting a Bid for the Project. All official notifications, addenda, and other Bidding Documents will be offered only through the designated website. Neither Owner nor Engineer will be responsible for Bidding Documents, including addenda, if any, obtained from sources other than the designated website.

Printed copies of the Bidding Documents may be obtained by paying a non-refundable deposit of $300 for each set.

The Issuing Office for the Bidding Documents is:
Engineering Service 115 Aero Smith Drive Richland, MS 39218

Prospective Bidders may examine the Bidding Documents at the Issuing Office on Monday through Friday between the hours of 8:00 a.m. to 5:00 p.m.

Instructions to Bidders.

For all further requirements regarding bid submittal, qualifications, procedures, and contract award, refer to the Instructions to Bidders that are included in the Bidding Documents.

American Iron and Steel

Section 746 of Title VII of the Consolidated Appropriations Act of 2017 (Division A – Agriculture, Rural Development, Food and Drug Administration, and Related Agencies Appropriations Act, 2017) and subsequent statutes mandating domestic preference applies an American Iron and Steel requirement to this project. All iron and steel products used in this project must be produced in the United States. The term “iron and steel products” means the following products made primarily of iron or steel: lined

or unlined pipes and fittings, manhole covers and other municipal castings, hydrants, tanks, flanges, pipe clamps and restraints, valves, structural steel, reinforced precast concrete, and Construction Materials.

The following waivers apply to this Contract:

De Minimis,
Minor Components,
Pig iron and direct reduced iron

This Advertisement is issued by:
By: Louis Hand
Title: Manager
Date: September 10, 2021 and September 17, 2021