20-E-8213 2019 Water System Improvements Contract IV - Shop
Bid Date10/12/21 10:00am
Company & Contacts
Lori McIntire 601-939-8737
Bids for the construction of 2019 Water System Improvements, Contract IV Shop will be received at the office of the Engineer, located at 115 Aero Smith Drive, Richland, MS 39218, until 10:00 a.m. on Tuesday, October 12, 2021. At that time the Bids received will be publicly opened and read. Electronic bids will not be accepted for this project.
The Project includes the following Work:
9,600 SF shop facility and appurtenances
Obtaining the Bidding Documents
Information and Bidding Documents for the Project can be found at the following website:
Bidding Documents may be viewed and purchased from the designated website. The website will be updated periodically with addenda, lists of registered plan holders, reports, and other information relevant to submitting a Bid for the Project. All official notifications, addenda, and other Bidding Documents will be offered only through the designated website. Neither Owner nor Engineer will be responsible for Bidding Documents, including addenda, if any, obtained from sources other than the designated website.
Printed copies of the Bidding Documents may be obtained by paying a non-refundable deposit of $250 for each set.
The Issuing Office for the Bidding Documents is:
Engineering Service 115 Aero Smith Drive Richland, MS 39218
Prospective Bidders may examine the Bidding Documents at the Issuing Office on Monday through Friday between the hours of 8:00 a.m. to 5:00 p.m.
Instructions to Bidders.
For all further requirements regarding bid submittal, qualifications, procedures, and contract award, refer to the Instructions to Bidders that are included in the Bidding Documents.
American Iron and Steel
Section 746 of Title VII of the Consolidated Appropriations Act of 2017 (Division A – Agriculture, Rural Development, Food and Drug Administration, and Related Agencies Appropriations Act, 2017) and subsequent statutes mandating domestic preference applies an American Iron and Steel requirement to this project. All iron and steel products used in this project must be produced in the United States.
The term “iron and steel products” means the following products made primarily of iron or steel: lined or unlined pipes and fittings, manhole covers and other municipal castings, hydrants, tanks, flanges, pipe clamps and restraints, valves, structural steel, reinforced precast concrete, and Construction Materials.
The following waivers apply to this Contract:
Pig iron and direct reduced iron
This Advertisement is issued by:
Owner: SOUTH CENTRAL WATER ASSOCIATION, INC.
By: Louis Hand
Date: September 10, 2021 and September 17, 2021